Install Vinyl Siding: Specific Measurements for Vinyl Siding Installation

Install Vinyl Siding

Vinyl siding is mostly patronized because it is long-lasting and cost-effective compared to other available sidings. If you plan to install vinyl siding, you need to know the specific measurement to begin the process. The rest of the shelter will be adequately protected from elements when the vinyl siding is well-installed by a professional installer. However, the installation of vinyl siding is more challenging than it looks. Hiring a professional with several siding installations and enough experience will help you get the best. Here is a simple guide to the perfect measurement of vinyl siding.

Install Vinyl Siding: How to Factor the Square Footage of the Building

Before attaching the first panel, the installer must have an estimate and accurate order of the needed materials. It would be wasteful to have excess materials and frustrating if they are insufficient. Hence, the estimate is so essential. Measuring the square footage would help get the required materials for the project. The square sells vinyl siding material. This is equal to 100 square feet of material. Therefore, if the square footage of the building is 3000 square feet, you would be dividing the figure by 100. So, for a 3000 square foot home, 30 squares of vinyl would be required. As a rule of thumb, it is recommended that an extra siding should be purchased. In the case of errors during installation, these extras can be used as replacements. 

Steps to Ordering the Perfect Siding Types

You can start working on the estimate as soon as you have discovered the square footage and the number of squares of vinyl siding needed for the project. It should be noted that the above measurement assumed that each wall was fully covered by vinyl siding. The measurement may become complex if you resurface the exterior walls with vinyl siding. In this case, your calculations would be required to be more accurate so you can get the correct number of vinyl siding and other materials needed to install vinyl siding.

Getting An Estimate Based on the Type of Siding Required

It is quite understood that all the siding needed for the project is vinyl. However, there are different kinds of siding depending on its requirement:

  1. Starter Strip: This is the material used at the bottom of the wall to create an easy attachment and a beautiful look. Starter strips are attached around the whole perimeter of the building.
  2. Corner Trim: This covers the exterior edge of the siding at the corner. The siding can meet at an interior corner for a better finish and look.
  3. J-Channel Trim: The J-Channel trim protects the exposed edges on the sides of the vinyl siding. This material is mostly used around doors and windows, also at the top of the wall under the soffit. Assuming your exterior has other materials like stone and brick, the J-channel can smoothen areas where the two materials meet.
  4. Utility Trim: This can be referred to as an under-sill trim. It protects the exposed top edge of the siding at the horizontal surface.

Conclusion

For learners, this process could be very complicated, especially when it comes to knowing how much of each type of vinyl siding is required to install it perfectly. The process can be easier when you hire a professional installer to handle the project. Search within your locality today to find a reliable siding installer.