For your furnace to perform efficiently during colder seasons requires care and adequate maintenance. With effective furnace maintenance, you can rely on your furnace to serve you all around the season. Abiding strictly to the caution measures will save your furnace from sudden technical faults. All you need is the assistance of an HVAC technician to take care of your furnace regularly. Here are some tips that will serve you for the winter season.
Effective Furnace Maintenance Tips
These listed preventive measures are vital if you want to extend the lifespan of your furnace and make it work efficiently without any form of breakdown.
1. Prompt Maintenance
When a fault is detected in your furnace, a prompt repair will help prevent it from expanding into a worse condition. This will help extend the furnace’s lifespan and eliminate costly repairs due to negligence. Timely and advanced maintenance is recommended to save you from many unseen conditions.
2. Thermostat
Your thermostat is another part of your furnace that needs to be taken care of properly. Tight or tangled wires and exposing them to the element can weaken the thermostat. Please switch off the power and give the wire a light pulls to ensure they are correctly fitted. Also, call your HVAC technician immediately if there are any leaks, cracks, or other apparent damages.
3. Lubricate Blower Motor
Some furnace systems make use of blower motors that need lubrication. If your furnace falls into this category, ensure you lubricate the motor bearings. To do this, you have to turn off the power, open the lid, and then clean the caps covering the bearings. Lastly, remove the caps and begin the lubrication.
4. Eye Test
There are obvious signs you can detect with your eyes that will reveal to you the status and maintenance requirements of your furnace system. You can detect if you need to install a heater by observing different components of the furnace. See that the venting pipe of the gas furnace is fastened securely and angled. Look out for other components like the and check your filter status.
5. Clean Furnace
Dirty furnaces tend to consume more power and energy to work effectively.
So, ensure to clean your furnace regularly to avoid costly furnace repair. Build-ups of dust and debris can cut down its performance and may lead to a breakdown. To remove unwanted particles without tampering with the furnace’s delicate parts, carefully clean the inner components.
6. Install Carbon Monoxide Detectors
Every gas furnace should come with a carbon monoxide detector. This is a proper guard against the harmful effects of the gas furnace. The batteries of your detectors should be replaced at least within 6 months. Also, test your detector regularly for optimal efficiency.
Conclusion
In conclusion, water leaks are another aspect to check. Water can leak out of the unit into a drip pan via drainage tubes in furnaces. Backed-up water can damage the flame sensor. This can lead to shutting down the whole furnace system. Effective furnace maintenance is essential. Therefore, you need to schedule proper maintenance with your local HVAC technician. Note you cannot service and maintain your furnace on your own if you are not a trained HVAC technician.
